Mcz Stripe Overnight Bedienungsanleitung PDF herunterladen (Seite 13)

2-INSTALLATION INSTRUCTIONS

CHIMNEY

The chimney is the fundamental element for smoke expulsion and must therefore comply with the following requirements:

• Be waterproof and thermally insulated.

• Be made of suitable materials that resist mechanical stress over time, heat, the eects of the combustion products and any possible

condensation.

• Have a vertical set-up with deviations from the axis of no more than 45° and free of bottlenecks.

• Must be suitable for the specic operating conditions of the product and have the CE marking (EN1856-1, EN1443).

• Must be adequately sized for the draught/smoke expulsion requirements that are necessary for the product to operate correctly

(EN13384-1).

• The chimney must not be shared with other appliances.

• The chimney must be at least category T400 (or higher if required by the smoke temperature of the appliance) and soot-re resistant.

Resistance to moisture is mandatory if this is required by chimney size.

• The internal section is preferably circular.

• In the case of a pre-existing product that has been used, it must be cleaned.

The chimney is fundamental for correct operation and safety of your product.

In the event of poor weather conditions for product operation (low pressure, external temperature not particularly

harsh, windy day), may lead to inverse draught in the chimney. In this case, it is recommended to use a little paper to

ignite the re to heat the chimney and restore normal draught. Then proceed with normal product start-up.

A) CHIMNEYPOT

B) CHIMNEY

C) SMOKE DUCT

D) EXTERNAL AIR INLET

TYPICAL CHIMNEY INSTALLED CORRECTLY WITH A

CHAMBER WITH SEALED DOOR AT THE FOOT OF THE

EXTERNAL RISING SECTION, TO COLLECT AND REMOVE THE

SOLID MATERIALS PRODUCED DURING COMBUSTION.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Keine Kommentare

Mcz Stripe Overnight Bedienungsanleitung Seite 13