Mcz Stripe Overnight Bedienungsanleitung PDF herunterladen (Seite 27)

5-OPERATION

START-UP PRECAUTIONS

Make sure you have read and fully understood the contents of this instruction manual.

Remove all components that could burn from the rebox and door (instructions and various adhesive labels).

Remove the stickers from the ceramic glass otherwise the high temperature could melt them and cause irreparable damage to the glass.

The product can be positioned at an angle or against the wall.

Avoid touching the product during the initial start-up, as the paint completes its drying process and hardens during

this phase. It is good practice to guarantee eective ventilation in the room during the initial start-up, as the

product will emit some smoke and smell of paint, which is absolutely normal!

If necessary, touch up the paint with the spray can of the specic colour.

Do not stand close to the product and air the room. The smoke and smell of paint will disappear after about an hour of operation, however,

remember they are not harmful in any case.

The product will be subject to expansion and contraction during the start-up and cooling phases, therefore light

creaking noises may be heard.

This is absolutely normal as the structure is made of laminated steel and must not be considered a defect.

It is extremely important to make sure the product is not immediately overheated and the temperature increases

gradually.

This will prevent damaging the welds and the steel structure.

Do not expect heating eciency immediately!

FUEL

FUEL: Wood

In order to achieve maximum eciency from your product, it is of utmost importance to use wood with adequate characteristics.

Oak-beech-ash-locust wood or logs of non-resinated pressed logs can be used.

The latter have a high caloric value and must be used with caution to avoid overheating that could damage the product.

Fuels such as poplar-pine-linden-chestnut have a low caloric value as the wood is soft. Moisture content is fundamental for all the listed

types of wood.

Wood drying time

(e.g. beech)

Moisture

Caloric power

Kcal/h

Freshly cut 50 /

3 Months 40 2410

6 Months 35 2700

9 Months 30 2900

12 Months 25 3150

15 Months 20 3400

18 Months 15 3710

21 Months 10 3980

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Keine Kommentare

Mcz Stripe Overnight Bedienungsanleitung Seite 27