Mcz Philo Bedienungsanleitung PDF herunterladen (Seite 36)

PELLET STOVES Chapter 7

USE AND MAINTENANCE MANUAL

page 36

 All the necessary measures and/ or precautions must be

taken when carrying out maintenance, cleaning and

repair work.

 Do not tamper with the safety devices.

 Do not remove the safety devices.

 Connect the stove to an efficient smoke outlet system.

 Check in advance that the room in which the stove will

be installed is suitably ventilated.

7.2. ALARM SIGNALS

In the event of an operating fault an alarm is triggered and the stove

shuts down, informing the user which type of fault has been detected

via a 3-digit code that is displayed permanently on the emergency

panel on the rear of the stove.

The alarm is signaled permanently by the relevant three-digit code via a

red flashing light that always appears on the emergency panel. For the

first 10 minutes, the alarm is also signaled by a regular acoustic signal.

To get the stove out of the alarm condition and restore normal

operating status, read the instructions in paragraph 2, below.

The table below describes the possible alarms signaled by the stove

and the respective code displayed on the emergency panel, together

with useful suggestions of how to remedy the problem.

WORDING

DISPLAYED

TYPE OF FAULT SOLUTION

A01

Fire failed to ignite

Check the pellet level in the tank.

Check whether the brazier is correctly seated and

ensure that it does not have any evident incrustations

of unburned fuel.

Check whether the pellet igniter heats up.

A02

Abnormal fire extinguishing

Results from fire extinguishing due to lack of fuel (tan

empty).

A03

he temperature of the pellet tank exceeds

the safety threshold specified.

Overheating of the stove structure

The stove structure is too hot because the appliance

has operated for too long at maximum power or

because it is poorly ventilated or because the air fans

are faulty. When the stove is cold enough, press button

B on the control panel or OFF on the remote control to

cancel alarm A03. Once the alarm has been cancelled,

the stove can be restarted as normal.

A04

he temperature of the exhaust smoke has

exceeded preset safety limits

he stove automatically shuts down. Leave the stove

to cool down for a few minutes and then restart it.

Check smoke outlet and the type of pellet used.

A05

Flue pipe obstruction - wind - door open. Check the smoke duct and close the door.

A06

he smoke extractor cannot guarantee the

required amount of primary air for correct

combustion.

Draught problem of brazier blockage.

Check whether the brazier is blocked by incrustations

and clean it if necessary.

Check the smoke dust and air inlet and clean them i

necessary.

A08

Smoke blower faulty

Check that the smoke blower compartment is clean to

ensure that no dirt is clogging it. If this does not

resolve the problem the smoke blower is faulty. Call an

authorised service centre for it to be replaced.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 45 46

Kommentare zu diesen Handbüchern

Keine Kommentare

Mcz Philo Bedienungsanleitung Seite 36

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Mcz Philo